Surface 10m Wind output only

Discuss advection schemes, timestepping, pressure gradients, coordinates, etc.

Surface 10m Wind output only

Postby billreilly » Sat Feb 21, 2009 3:09 pm

I want to run simulations where i only need Surface 10m Wind output... Is there a way to run the WRF model so that it will only output these fields and ignore all other fields and levels?

I basically want to speed up the entire model run, as I have many small domains that need to be run one after the other.

It seems a waste of time and resources to crunch out many levels and fields when i only want these...

Any help would be most appreciated...

Posts: 1
Joined: Sat Feb 21, 2009 3:01 pm

Re: Surface 10m Wind output only

Postby PrometeusWillLive » Fri May 08, 2009 3:20 am

Bill, you could use Ferret software.

You can extract your numerical data, point by point and attach to an excel file. Or if you need to analyze it in a graphical way, I mean, check your domain, Ferret can enable you to do it.

I hope it can be useful! Sorry if I could not completely satisfy your doubt.
Posts: 25
Joined: Fri May 08, 2009 2:59 am

Re: Surface 10m Wind output only

Postby zeomkean » Wed Mar 25, 2015 3:40 am

Where can i find full descriptions of every state and i1 variable in Registry.EM? I'm trying to select some useful variables from them but i find many of the variables don't have description and i don't know that's their meaning.
Posts: 1
Joined: Wed Mar 25, 2015 3:37 am

Return to Dynamics and Numerics

Who is online

Users browsing this forum: No registered users and 3 guests