Hi,
1) How to configure WRF for PU execution? Any documentation on the same?
2) Which are the physics packages, implemented for GPU execution?
3) Any particular version of WRF, which support GPU?
4) Does WRF4.0.2 support GPU execution?
Thanks.
Ancy
configure wrf
4 posts
• Page 1 of 1
Re: configure wrf
by kwthomas » Thu Jan 10, 2019 5:15 pm
Ancy...
There are bits a pieces of code for GPUs in WRF, none of them documented. I wouldn't waste my time
trying.
There are bits a pieces of code for GPUs in WRF, none of them documented. I wouldn't waste my time
trying.
Kevin W. Thomas
Center for Analysis and Prediction of Storms
University of Oklahoma
Center for Analysis and Prediction of Storms
University of Oklahoma
- kwthomas
- Posts: 279
- Joined: Thu Aug 07, 2008 6:53 pm
Re: configure wrf
by ElliotGi » Sat Feb 02, 2019 9:01 am
Would this be useful to anyone if it was compiled by the way?
- ElliotGi
- Posts: 1
- Joined: Fri Feb 01, 2019 6:09 am
Re: configure wrf
by kwthomas » Fri Feb 08, 2019 6:45 pm
Yes, a fully supported WRF for GPU's would be wonderful. FV3 would be great too.
BRIDGES/PSC has GPU's. I do a lot of WRF runs there in support of the NOAA Hazardous Weather Testbed
experiment.
The one big "gotcha" may be that WRF usage will decrease, at least of us, as FV3 ramps up. I'll be running
FV3 SAR this spring on STAMPEDE2/TACC.
BRIDGES/PSC has GPU's. I do a lot of WRF runs there in support of the NOAA Hazardous Weather Testbed
experiment.
The one big "gotcha" may be that WRF usage will decrease, at least of us, as FV3 ramps up. I'll be running
FV3 SAR this spring on STAMPEDE2/TACC.
Kevin W. Thomas
Center for Analysis and Prediction of Storms
University of Oklahoma
Center for Analysis and Prediction of Storms
University of Oklahoma
- kwthomas
- Posts: 279
- Joined: Thu Aug 07, 2008 6:53 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests
Looking for data to run the WRF? Visit:
Need help setting up or configuring the WRF? Visit:
