Page 1 of 1

Changing parameters

PostPosted: Thu May 21, 2009 1:48 pm
by PrometeusWillLive
Dear sir in charge of WRF, dear all,

I have been trying to couple a software to simulate urban conditions (UCM), and it has different input parameters compared to Kusaka model.

I have shifted some of them in physics, namely the following files:
-module_sf_noahlsm.F
-module_surface_driver.F
-module_physics_init.F

For my surprise, when I compile the entire program again, the correspondent files in main directory simply disappear.
-module_sf_noahlsm.mod
-module_surface_driver.mod
-module_physics_init.mod
-module_myucm.mod

What should I do to solve the problem? By the way, may it be a problem of my software?

Thanks in advance,

Re: Changing parameters

PostPosted: Wed May 27, 2009 4:15 am
by jimmyc
Hi-
It sounds like the new code did not compile. The compile log file should have line numbers (hopefully) so you can go back and check your code (the files where the line numbers are referenced are the *.f files since these files have the comments stripped out by the parser).
jimmyc

Re: Changing parameters

PostPosted: Sun May 31, 2009 9:21 pm
by PrometeusWillLive
Hi James,

Thanks for your hint. I will check it again.

Re: Changing parameters

PostPosted: Fri Jan 16, 2015 2:23 pm
by BTG
Hello,
I am trying some modifications into WRF modules in the subdirectories, and was wondering if I could compile only the subdirectory by using its Makefile instead of compiling the whole code.

As an example, I am trying to compile subdirectory WRFV3/frame only, but make fails with the following error:
make[338]: execvp: /bin/sh: Argument list too long
make[338]: *** [esmf_time] Error 127
.
.

Any information would be appreciated.
BTG