One-way nesting using ndown.exe

Discuss the nesting capability within the model itself and any problems you might have run into.

One-way nesting using ndown.exe

Postby georgeg » Wed May 25, 2016 7:23 am

Hello everyone.

Following the model manual I managed to to a one-way nested simulation using ndown. Both ndown and wrf executables ran succesfully for one additional domain, using boundary conditions from the previous model run.

I was wondering if I could use the same procedure for two additional domains. I tried to do that, but although ndown.exe ran without any problem, it produced the wrfinput file for just one domain. I there something that I have to keep in mind, or ndown can only be used for one additional domain?

Thanks in advance,
Posts: 7
Joined: Tue Apr 28, 2015 3:32 am

Return to Nesting

Who is online

Users browsing this forum: No registered users and 2 guests